Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Let me start by defining the end goal: Utilize an active/active ASA to filter traffic on specific network segments (VLANs). There is a 3750 stack which is acting as the VTP master. I'm having trouble understanding how routing will work in this sce...
I believe that version 8.x of the ASA supports Active/Active VPN failover. I looked quickly and couldn't find the notes on this, but I know that this is something I asked about in the past and was told 8.x will support this. Dan
Thanks - I see that, but I was having problems understanding how traffic would be routed back to the VLANs on the network that aren't configured on the sub-interfaces. The answer was to configure a dedicated interface connected to the 3750 switch st...
Here's some more information. I've simplified my config and I can't get Access-controls to work on VLAN 16. I have two VLANs defined on the ASA 16 and 80:interface GigabitEthernet0/0 no nameif no security-level no ip address!interface GigabitEthern...
