Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a very simple SDA setup. One fabric edge node which clients connect too, and one Border/Control Plane Node that connects out to the rest of our Non-Fabric environment, specifically a N7K Fusion Router. Our DHCP server is out in the Non-Fabric...
I changed back to Lisp PUB/SUB as opposed to LISP/BGP.I couldn't get it working until I ensured that there was a default route on the DEV VRF on the Border+CP Node. After checking the routing table, I realized there was no default route set for that ...
Fabric Edge: IOS XE 17.90.04a C9407RBorder/Control Node: IOS XE 17.9.4a C9410RCommands were captured on the respective nodes listed in bold. As for the CLI show commands near the top, those were captured on the fabric edge.Fabric Edge does NOT have a...
