Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there. I'm trying to configure an ASA5510 with no luck.My network is very simple. Computers on the inside with a single router connected to the internet. Use NAT to protect inside addresses and allows access to cetain machines with static addresse...
Hi thereI'm new to Cisco and our ASA 5510. I'm not new to firewalls in general but this is my first time working with a Cisco product.I have configured my ASA with all my network info but it is not allowing any computers connected to my network to a...
Thanks for your reply, so what would be the appropriate CLI commands to enable the nat 0?I don't use a pool of addresses, just a single address for outgoing traffic if that helps you.Should I post my config so you can get the whole picture? Again, If...
