Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i'm new here and i'm peased to join your community.I've an issue on a pair of PIX 5525 8.0(3)12 in Failover Active/Standby Config.If i do a show failover state mi output is the following: State Last Fa...
I also done a "show start" on the failover standby node, and the output is the same doing "show run". Some one suggested to do this, but i don't see the comment anymore. KR
Hi,i can not try a failover active to avoid failures.Anyway, here is the output of your suggested commands:FWNAME# failover exec mate show run failoverfailoverFWNAME# show run failoverfailoverIf i do a show run i see these lines i wrote in the first ...
