Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA at a remote office. They have two VLANS. One for 192.168.0.0/24 called 'inside'. The other for 192.168.1.0/24 called 'inside2'. The 'inside' vlan has no issue with accessing the internet. Inside2 can't access anything even though f...
What version of ASA firmware are those commands valid on. I keep getting errors on 8.4(2).I'm about to take a hammer to the unit. I have others that have never given me this much grief.
Here is the output from the show runs... phasa01# show run nameif!interface Vlan1 nameif inside security-level 100!interface Vlan2 nameif outside security-level 0!interface Vlan12 nameif inside2 security-level 100!phasa01# show run nat!object network...
