Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ASA 5520 with three interfaces - inside, outside, and now newly created DMZ - all physical interfaces on the FWInside interface is connected directly to layer 2 switch with port on switch set as access port for a specific VLAN 601This layer 2 switch ...
VLAN needs to be created and defined on FW then? Usually this is done on our Catalyst 6509 which is why I'm a little confused. Only thing that has been done on FW is INT created/configured and enabled.Right now host is configured with IP address in ...
I understand what you are saying here but my question is:What gateway address am I point my new DMZ hosts to? The IP associated with the internal interface on the FW?
So important point:Firewall is actually at a remote site with the layer 2 2960 switch and relocating DMZ server canidates to that location from the data center where the 6509 is located isn't an option. There is a default route on the 6509 that poin...
