Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have a dmvpn hub setup with several spokes attached.I run eigrp between hub and spoke and inject a default route to the hubs so all traffic is routed via the tunnel interface on the spokes.I need to enable internet access for a customer over the...
Hi Thanks for you assistance.I don't need to create a spoke to spoke tunnel.I need to let the customer surf the internet. I have enabled this locally using a route map which nats all non hub destined traffic out the outside interface.I had to change ...
The config below did the trick for me.I proxy arped the public address to my inside address.Both hub and spoke are in transport mode.I also had to add the no nat so my other translations weren't affected.access-list outside remark DMVPN Permissionsac...
