Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured NAT and access control on firepower ftd but it doesn't seen to work. I have a draytek router that connects to ISP via PPPOE and my firepower connects to the draytek, on intf1, intf3-8 is a vlan which connects 3 webservers and they a...
On the Draytek Port redirection is what is implemented, the source IP is the server's and dest IP is the the static from ISP. I have remove the ports from NAT in FP FTD and only use ACL to filter the destination ports
Yes so static Nat from 192.168.20.x to 192.168.2.x shows and overlap to 192.168.2.x which is the outside, same with PPOE to outside hence the deployment failed.
There is a NAT policy already on Draytek router which works without the firepower FTD, I have configured PPPOE on FP Interface with all the settings used in the Draytek but it doesn't seem to allow internet through hence why am using both.
