Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a new ASA 5510 running 8.3(1) and ASDM 6.4(5)I am trying to use the real time log viewer to help troubleshoot some access issues, but I am getting delays of up to 30 seconds or more between my client conecting to the ASA and the corresp...
Hi All,I'm in a sort of "half way house" situation with an ASA running 8.3(1), a range of public IP addresses and a requirement to access many different internal hosts using a series of port forwarding options. I have read (and understand fully) the ...
Hi,Got a pair of 5510's in Active/Passive failover config. Been in and running for about 9 months. Running 8.3(1)About 3 weeks ago I started seeing the units failing over on an almost daily basis. Failover has hardly ever happened before then.Can any...
Thanks once again.While your statement about a busy firewall and the number of discarded messages makes sense in some respects, I'd appreciate a bit of an insight as to "what" is so busy.This is a relatively small site - maybe 100 users - but with a ...
Hi Varun,Thanks for coming back .... here's the two outputs you asked for.I've previoulsy tried disabling as much logging as possible (e.g. only to ASDM) but nothing seems to have any effect.You will see the two specific syslog IDs that I disabled a...
Just an update for anyone who may be interested. We power-cycled the Secondary unit about a week ago, the Primary failed over about 24 hours later. But this time the Secondary has stayed Active for a week, the longest since we started seeing the iss...
Thanks again for rapid response Both units were installed back in April 2011 and I believe they have 1024 MB, they have not been touched since the initial install, so a loose memory module is unlikley I would have thought.I've seen another post somew...
