Hello Experts.
Could you help me on the following? I have to find flapping interfaces in the fabric.
Theoritically I can do it in ugly way which is run a script which will execure show interface on each node of the fabric and then run a condition i...
Hello Experts,
I was given the contracts name. I have to delete the contract along with assosiated EPGs.
I cannot figure out a was where I can pull the EPG list based on the contract.
I see there is 2 commands show contract XXXX and show tenant ...
Hello ACI experts.
I am very new in ACI and does not have any coding skills whatsoever.
I have a task to fill up report on power supply status of the fabric.
I believe there could a way to pull such information from the APIC using moquery com...
Hello Experts,
I am troubleshooting a very obscure problem.
I have created an External routed L3out OSPF profile and applied it to to Leaf 102.
I have also specify the interface selector which is 1/1
I have also confifured L3 routed interface ...
Hello Experts.
I have a pretty obscure issue with ACI L3out configuration.
I have configured an OSPF on a routed interface and attached to the LEAF 101 inteface 1/1.
I connected a Nexus switch to the interface 1/1.
I can ping the interface IP ...
Hello Remi, Thank you very much!Could you tell me please if the link flapped say for a second, will such thing be accounted as event?Could you tell me please what could be the difference berween an event and fault.
Hello,
Could you please aleborate on the following
(2) Within the Application Profile, under the EPG, right click on the "Contracts" folder and select either "Add Provided Contract" or "Add Consumed Contract" depending on your desired traffic flo...
