Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 5 statically assigned IP addresses from my ISP and I use a Netopia 3364 DSL modem for PPPoE authentication. This box is able to split out the public IPs to downstream firewalls, routers, etc, but when I connect my ASA 5505 to it and assign it...
Well, I did a reset to factory defaults and configured NAT within the address range given to me by the ISP; after a few minutes, it worked, so I guess the problem was in address translation across the interfaces.
Here's the running config output. I'm not sure if it's entirely correct. I got the next ip address from the Netpoia web page.ASA Version 7.2(2) !hostname ciscoasadomain-name default.domain.invalidenable password xxxnames!interface Vlan1 nameif insid...
I presume you set a default route using the setroute option, but this is not available if you use the "ip address [ip_address [mask]]" command. When I try to use the "ip address [ip_address [mask]] pppoe [setroute]" command, I get an error.
