Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to upgrade from a Pix501 to a new ASA 5510. I ran thepixtoasa tool and now have the followingconfiguration:ASA Version 7.2(2)boot system disk0:/asa831-k8.bin:::: Interface mapping - {'ethernet1': 'Ethernet0/1', 'ethernet0': 'Ethernet0/0'}...
I am trying to create a site-to-site ipsec tunnel. My first attempt failed and I was given some information from someone using an ASA (8.0?) for my second attempt. They were not sure of the compatibility of some of the commands and I ran into an erro...
Scenario: I need help setting up a “Business to Business (B2B)” connection from a vendor to host facility (may also be called a shared IPSEC Tunnel?). I want to add this new tunnel configuration without impacting the current setup on the PIX. Not tha...
Anyone know if (and how) licenses between 2 identical Pix devices can be transferred to just one of them. My problem is that I have 2 Pix 501s.... one has VPN-3DES-AES enabled, but only 10 inside hosts allowed. The other has Unlimited inside hosts, b...
Anybody know where I can purchase an unlimited user license for a Pix 501. I have installed and configured the firewall (much thanks to Jorge, here in support forum), but quickly realized that an office of 60 users became an office of 10 online syste...
Thanks! No, unfortunately I only provide onsite service to that office every Friday. I was planning on configuring the 5510 before I went to save time and test it early Friday before the office opens. I should have known better than to try the bleedi...
I am going to try the nat-control command and then the ping process from inside IPs. I will post the results. It may be Monday before I am able to do so, as I have to do request the temporary outage on the company network. Thanks to all who are follo...
Assuming my LAN is 192.168.1.1 through 255 and there may be 100 users connected to the outside at any given time, would either of these configurations work: # object network my-outside-ips# range 10.1.1.1 10.1.1.101# object network my-inside-net# sub...
Hi Edward, I did nothing to the configuration as it was in the PIX, other than run the PIXTOASA.exe conversion utility. Is there something I else I should do for the NAT configuration in the ASA? I don't have it handy, but I am pretty sure it is runn...
