Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It is true that both the csc-ssm and aip-ssm modules can't co-exist in the ASA5500 device at the same time.There isn't a sample configuration availavle onsite yet. However, apart from the same-security command, you would need the regular translation ...
If a failover has occured and the secondary(FO) unit is active, the FO unit will continue to run without interruption. If the FO unit is working as an active unit without the primary connected then it will reboot every 24hours.Please rate if this hel...
You may create a sub-interface on the outside interface and use it as a backup interface. Here is a sample config :http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/conf_gd/ref/examples.htm#wp1038632Please rate if it helps.Sincere...
The interface mode command is "no management-only"Configuring Active/Standby Failover http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/conf_gd/general/failover.htm#wp1058096Sample Config:http://www.cisco.com/univercd/cc/td/doc/pr...
As mentioned above, its a known issue with older version of PDM. Please upgrade the PDM version to 3.0(4), you may download the code from:http://www.cisco.com/cgi-bin/tablebuild.pl/pixTo upgrade using a tftp server, use the command: copy tftp flash:p...
