Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a pair of redundant CSS11503 load-balancing two HTTP servers. I need to permit access to specific subset of URLs on those two HTTP servers to anybody on the Internet, while rest of the URLs should be allowed for specific range(s) of IP ...
After upgrade of my 515 (not 515E), the average CPU usage went from 4% to around 12%. ACLs are same and so are the traffic patterns/load. Firewall ran 6.3(1) before the upgrade.Any idea why this could be the case?TIA,haver
Is it possible to configure a CSS11503 running 7.20 to use TACACS+ as primary authentication and have it use local authentication when switching to SuperUser/enable?Thanks,haver
Hi all,I need to redirect HTTP traffic originating from a specific range of IPs to a specific farm of HTTP servers. More specifically, I need request comming to CSS's outside VIP address on port 80/tcp to be redirected to the HTTP farm (2 boxes with ...
Is it possible to translate destination ports traversing the PIX? I have a situation where I need to translate destination port 80/tcp to 30080/tcp on outside interface going to a DMZ (public IP range).Furthermore, this should only be done for specif...
I had to downgrade all my 6.3(3) PIX'es to 6.3(1). Not only did the CPU usage increased, but VPN stopped working and PIX'es stopped logging messages.Something is _really_ broken in 6.3(3) or they are not meant to be used with 515E or 515 series.Just ...
Here are the relevant outputs. I can't post the config here, but you can contact me at srseh@orange.dk and I'll send it in a private email.ows-devtest-fw# sh verCisco PIX Firewall Version 6.3(3)Cisco PIX Device Manager Version 3.0(0)148Compiled on We...
I don't think so. The incrased CPU usage happened right after upgrde to 6.3(3). I've been monitoring the firewall since, and everything is the same as before. I.e. number of average concurrent connections, memory usage, xlate counts, etc.
