About rasmussen.d

rasmussen.d · 03-23-2010

Have come across this issue in the past where rebooting the router causes the port forwarding feature to stop functioning on the RVS4000. The only way we were able to get it working again was to reset the router to factor defaults then upload a saved...

rasmussen.d · 11-09-2009

Currently trying to establish L2TP IPSec VPN tunnels between Windows XP remote client and Windows 2003 RRAS Server.Both the XP remote client and the W2003 RRAS Server are behind RVS4000 routers.Have established that the W2003 RRAS server will accept ...

rasmussen.d · 07-28-2010

I've had this problem with both the RVL200 and RVS4000 with 2 different Internet Service Providers.One is Verizon residentail service with a 7mbps down that over the course of a few hours will drop to 2.9 mbps.This is using the RVL200. With the RVS4...

rasmussen.d · 11-18-2009

Found out that IPSec using a preshared key with the RVS4000 does not work. TAC case pending. IPSec using a certificate worksbut only with the Windows 7 VPN Client which you can specify what certificate to use. With Windows XP VPN client, you can not ...

rasmussen.d · 11-10-2009

Will try UDP 500 for IKE and see if that works. Thanks for the response.note: the RVS4000 single forwarding and port triggering rules only allows 1 L2TP IPSec rule. If you try to configureother L2TP IPSec port forwarding rules, the router says there ...

Member Since	‎01-16-2007 02:56 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	5

User Statistics

User Activity

RVS4000 1.3.1.0 Port Forwarding failure after reboot.

RVS4000 L2TP IPSec

Re: Router speed issue

Re: RVS4000 L2TP IPSec

Re: RVS4000 L2TP IPSec