Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a Cisco PIX firewall 515E version 6.3 connected on one interface (eth1) to a linux PC (200.0.10.5 in subnet 200.0.10.0/24) and on the other (eth0) to a SoHo router (interface IP 200.0.11.2 in network 200.0.11.0/24 - behind the rout...
Hello everyone,So with some help we finally figured the problem out. Our firewall was a “standby” unit (back up firewall), so we had to define failover IP addresses.failover ip address outside 200.0.11.3failover ip address inside 200.0.10.2 After tha...
Hey Prapanch,Here are the outputs of "show nat", "show global" and "show static" from the PIX:pixfirewall# show natnat (inside) 0 access-list nonatnat (inside) 0 200.0.11.0 255.255.255.0 0 0 pixfirewall# show globalpixfirewall# show staticstatic (ins...
Ok, so I added:static (inside,outside) 200.0.11.2 200.0.11.2 netmask 255.255.255.255 0 0static (inside,outside) 200.0.12.1 200.0.12.1 netmask 255.255.255.255 0 0
... still doesn't work. I also checked the router and there are no access-lists on it,...
