Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a port forwarding issue, for some reason RDP and PLEX are both working on my setup, and I tried opening 8050 port with the same config as the rest of the port forward but unfortunately this did not work. I tried deleting and readding it, ...
to whom it may concern,
Just purchased RV320 to replace ISR 1800. I have a hard time setting up port forwarding to allow RDP and Plex ports to be opened. Following Cisco guidelines and google search did not help. Below is the settings currently confi...
Please help,
For some reason I keep getting denied when configuring port forwarding on an ASA 5510. The current topology is Internet----Modem-----Router--------ASA 5510 (Active/Standby)---------Inside------PHP_TEST
If I am allowing to open a web ...
Please help, For some reason I keep getting denied when configuring port forwarding on an ASA 5510. The current topology is Internet----Modem-----Router--------ASA 5510 (Active/Standby)---------Inside------PHP_TESTIf I am allowing to open a web serve...
Hi AJ,
Good day and sorry to bug you again. When you get a chance can you please let me know why the syslog traffic is not passing through. I verified the router via show logging and it’s generating logs; however, I checked the capture and no sys...
Hi AJ, Many Thanks again and I greatly appreciate your help. When I ran the packet trace, it shows successful but not getting logs. I'll work on it later.Anyways my priority is the RDP, with the configuration below, can you pin point why the conf...
Hi AJ,
I deleted my previous configuration and started it again. I am now able to do port forwarding. Many thanks again for your time and help. One more quick question, I am trying to send my Outside Router's syslog to Inside syslogserver. I ...
HI,
So it passes the test as seen below; but when testing this from internet (remote), I am unable to access it. It is fine when accessing the server inside LAN using local IP. By running what you suggested, it is able to see the configured port ...
