Hi Peter,In the snap shot you have attached, i see the source ip, destination ip, source port and destination port being set to 0.This does not mean that you are actually gettting packets with these parameters.If you look at the alert, you will see t...
Hi Fredrico,Even if there is a patting device that does patting, for each patted IP address, the ASA maintains a connection entry in its state table. It uses source ip, destination ip, source port , destination port and protocol to indentofy each fl...
What i mean is:If gi0/1 is the physical interfaceciscoasa1(config)# int g0/1ciscoasa1(config-if)# exitciscoasa1(config)# int g0/1.1ciscoasa1(config-subif)# vlan 10ciscoasa1(config-subif)# exitciscoasa1(config)# failover link failover GigabitEtherne...
It works exactly the same as physical interfaces.But 2 things to note here:>> If you try to use a sub interface as a failover interface, its gonna give you an error:"Can not configure failover interface on a shared physical interface"This is because ...
Hi Noel,Just a few checks regarding the hardware, software and license...Hardware:The two units in a failover configuration must have the same hardware configuration. They must be the same model, have the same number and types of interfaces, and th...