About GBInformatics

GBInformatics · 06-15-2025

Hello, I just noticed a configuration problem with my cisco RV345p router. I use a DDNS from Synology. Currently works perfectly. My problem is that it is configured on WAN1, which means that if it fails, the system will switch to WAN2, the DDNS will...

GBInformatics · 03-30-2025

I have configured a Cisco RV134W wifi router. This is connected to my Cisco SG350-28MP switch. The WAN IP address corresponds to a VLAN 10 address, i.e. 192.168.141.4. The LAN address is 192.168.143.x.Overall, it works fine, except that I can't acces...

GBInformatics · 02-17-2025

Hello,I would like to set up a security system in the event of a fault on two RJ45 ports. I want to configure two trunk links between the RV345P router switch and the SG350-28MP switch.On the Cisco SG350 switch side, I have followed this documentatio...

GBInformatics · 02-03-2025

Hello,I want to set up a configuration that allows me to ‘tidy up’ my equipment. To do this, I've created different VLANS (VLAN 10 Network equipment, VLAN 20 Servers, VLAN 30 Network peripherals, VLAN 40 DHCP clients).What I was thinking of doing :->...

GBInformatics · 01-16-2025

Hello,Can you help me configure the NAT to have internet with my router please?I can't do it at all with the Cisco router. I am not sure of anything. I am lost.If it's possible to remove the WAN 2 interface with the IP address 192.168.150.x/24 that w...

GBInformatics · 03-30-2025

Hi, I needed to tick the ‘Web Access’ parameter. Thanks

GBInformatics · 03-17-2025

is this what logs are all about?

GBInformatics · 03-08-2025

Hello, here are a few screenshots to help you understand.It's not totally active because afterwards I can't access anything. I prefer to ask first to see if it's configured correctly. Cisco SG350-28MPCisco RV345P

GBInformatics · 03-02-2025

Ah, I don't have a console cable. I do everything via the WEB interface.Do you know if it is possible to configure a LAG on a Cisco RV345 P router?

GBInformatics · 03-02-2025

Hi, I've set up a Graylog server to get logs but when I configure it, all the communications go down so no information comes up.I didn't understand ‘Mr’.Can I send you the configuration captures?

Member Since	‎12-02-2024 11:04 PM
Date Last Visited	‎06-15-2025 08:08 AM
Posts	68

User Statistics

User Activity

Configure WAN1 and WAN2 with DDNS synology

WebUI access blocking by SPI Firewall on Cisco RV134W

Configuration link aggregation between Cisco RV345P and Cisco SG350

Configuration DHCP with VLAN on router CISCO RV345P

Help configuration NAT on Cisco RV345P

Re: WebUI access blocking by SPI Firewall on Cisco RV134W

Re: Configuration link aggregation between Cisco RV345P and Cisco SG35

Re: Configuration link aggregation between Cisco RV345P and Cisco SG35

Re: Configuration link aggregation between Cisco RV345P and Cisco SG35

Re: Configuration link aggregation between Cisco RV345P and Cisco SG35