Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having an odd issue with my ASA 5510. 3-5 times a week a number of users will complain they can no longer access the internet, they have local network access but are unable to get past the inside interface of my ASA 5510. The only way to restor...
I'm trying to resolve a routing issue with our VPN client connections to corporate site PIX firewalls and can't seem to figure it out. I connect all of our corprate sites with PIX VPN Site-to-Site links, staff in each remote office can connect to th...
Hey Jay,When I issue a sh xlate count I get 57 current, 72 max connections. When I issue the show connect count I get 638 current, 1357 maximum connections. I checked and the timeout for xlate and connect are the defaults, should they be adjusted?...
Thanks, I should be able to test it at our corporate site by adding it to the config and then pinging and outside address? I was already looking at replacing the 506e's so I may need to do it sooner than expected.nick
I don't, I just found the command in another post for a different issue but wasn't sure if it would work in this scenario. I was just starting to check how to apply it, is there anything special when entering? Any additional commands needed? Also,...
