Hello, I am trying to do NAC for AP's 916x series and 913x series. However on some occasions the AP does not get added to Internal Endpoints and even if I add it it does not match the profiling policy. In auth report I can see it sending RADIUS attri...

Hello,I have an issue with AP's that during NAC implementation on the port they should first get profiled by sending device-sensor attributes to ISE and once they get profiled they should do CoA and hit the rule that allows them communication to WLC ...

Hello Everyone,Wanted to check with you if you've encountered such scenario where you had NAC enabled (multi-auth mode) on the Catalyst 9300 switch and on some ports there were some downstream switches connected that do not support dot1x/mab. I wante...