About Jacob Koenn

Jacob Koenn · 03-05-2025

Good morning!At my job, we have setup our two FPR 2130's running in ASA into an HA Active/Standby pair. This has been great for upgrades. Currently, when we manually enter the command "failover active" on the standby unit, it will failover, but not a...

Jacob Koenn · 03-05-2025

Copy, I will give this a try and mark as solution if this works, I appreciate the help everyone!

Jacob Koenn · 03-05-2025

Morning,Would be safe to throw on portfast on all ports containing the FW HA configs? Can you put portfast on a trunk'd interface/does it function when on a trunk?How it is setup:Eth1/20 FW-FW01Eth1/21 FW-FW01Eth1/22 FW-FW01Eth1/23 FW-FW01Eth1/24 FW-...

Jacob Koenn · 03-05-2025

Morning Rob, I do not have portfast configured on the ports going to both firewalls. **EDIT: We do have "spanning-tree port type edge" on some interfaces but not all, I will ensure uniformity of configs. I have also read, it is not recommended to ru...

Jacob Koenn · 03-05-2025

Morning, appreciate the response.On the standby unit, you may type "failover active". This will start a manual failover, this should automatically switch over all current active interfaces, to the standby unit, thus making the standby, the new active...

Member Since	‎03-05-2025 04:46 AM
Date Last Visited	‎03-12-2025 01:26 PM
Posts	5

User Statistics

User Activity

Cisco FPR 2130 (ASA) Failover Active/Standby takes 1 minute 30 seconds

Re: Cisco FPR 2130 (ASA) Failover Active/Standby takes 1 minute 30 sec

Re: Cisco FPR 2130 (ASA) Failover Active/Standby takes 1 minute 30 sec

Re: Cisco FPR 2130 (ASA) Failover Active/Standby takes 1 minute 30 sec

Re: Cisco FPR 2130 (ASA) Failover Active/Standby takes 1 minute 30 sec