Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,
I hope one of you can help me or point me into the right direction. Please be gentle i'm a newbe.
From my HQ i'm able to access internet through the ASA, and i would like my users at my branch site to use the same internet connection thr...
Hi Everyone,
This is my first post here and i hope you can help me or point me into the right direction. Please be gentle i'm a newbe
I'm trying to configure 2 x 3560 8 Ports as my distribution layer and 1 x 2960 8port as access layer, with ether c...
Hi Ahmedshoaib,
Thanks alot i found the error, i have removed default-information originate on PE2 under
router BGP 3292address-family ipv4 vrf DTLno default-information originate
And on PE1 i removed
router ospf 2 vrf DTLno default-information orig...
Hi,
I have removed default-information originate always and removed ip route 0.0.0.0 0.0.0.0 10.1.100.4 from the branch router.
and i have added the default-information originate always to both DSW in my HQ.
I don't get the loop anymore on the branch...
Hi;
Could you tell me if its posible to have the users on my second site access the internet on the HQ through the MPLS.
I guess i need to add the ip route 0.0.0.0 0.0.0.0 10.1.100.4 on the second router. but it just bounce of the PE2 router in my M...
Should the Router in the second site not also have the ip route 0.0.0.0 0.0.0.0 10.1.100.4 so it would now where to cast the trafic.
I'm unsure how to make a default route on the MPLS because what i have attempted in the previous post did not work, ...
I have tried to add ip route 0.0.0.0 0.0.0.0 10.1.100.4 to SW conected to PE1 and the Router connected to PE2and i have added default-information originate and redistribute ospf 2 match internal external 1 to both provider edge router.
but the result...
