Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are in the process of bringing up a new network core which will eventually replace the old. The old core has multiple 6509 Sup 1a and 2 engines and CSMs - Sw 4.1(5). The new core uses 6513s with SUP720s and CSMs with Sw 4.2(2). The new core ...
Documentation says -"The CSM can maintain a sticky database of 256.000 entries". Is that a typo - only 256.The default time for a sticky is 1440 (24hours). Is there a recommendation for timeout? What could setting the timeout to long result in?
Your response forced me to hit the Cisco configuration books on this one. Bridged mode vs secure router mode vs one-armed mode. Couldn?t remember which was what and what we were currently using.We are currently using the one armed mode on everythin...
I think I've found the problem but please verify. I failed to include the FWSM default GW in the server vlans 2056 & 3056. Attached is the CSM config file. The new serverfarm I'm having problems with is the VMSHRPT.
I've tested it again. It is a "Return Path" problem but I can't come up with a solution. Using a NATPOOL statement in the SF I can only get one of the Servers to successfully establish a session. The one in the same NATPOOL of course. Is there ano...
Thanks for your quick response. I tried this once but it appeared only one server would get a successful connection. I think you've diagnosed the problem. "Return Path" is the key.
