Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiMy asa is sitting behind a router the next hop from the ASA to the router is 10.0.0.5 I have tried to change the default route to route DMZ 0 0 10.0.0.5 to no availability right now the default route is (S* 0.0.0.0 0.0.0.0 [1/0] via 172.16.8.20,...
Hello,I was trying to connect 2 RVS4000 devices to each other creating a vpn tunnel but the status of the link is always "down". I have followed the instructions on the "Administration Guide" to connect a gateway to gateway vpn tunnel using static ip...
Thank you everyone for your help with my problem. After Marvin mentioned RRI I started looking at configurations and found this: "crypto map outside_map 1 set reverse-route" on the asa on the branch location. Before Marvin mentioned it I never knew w...
Hi Marvin,First I want to say thanks for your help... Yes there are 2 L2L vpns connected to this particular device. I did not know what RRI was until you mentioned it. Also OSPF was enabled on this device but disabled it when I was trying to troubles...
I apologize for not being clear hopefully this helps. Basically the default route should be: route DMZ 0.0.0.0 0.0.0.0 10.10.10.5, I had to add a metric of 2 because otherwise it would conflict with the Gateway of last resort, the interesting part...
