Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a setup where there are 2 x Cisco6509E Switches with FWSM and IDSM.I am trying to Loab Balance traffic to the 2 x IDSM using Etherchannel and can only do this when both IDSMs are in a single chassis, I check some Cisco sites which highlighted ...
Dear Farukkh,Thanks for the support. I have done the escalation within Cisco but am just getting the response as "The scenario we are looking for is not going to be supported in the near future".I was hoping someone (especially from Cisco) might have...
Hi Farukkh,First of all I appreciate your reply on my case. I know that ECLB is not supported with one IDSM on the Active Chassis and one IDSM on the Standby in a VSS setup. What I want to know if Cisco is working on a solution to this as it only mak...
