Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Thanks all in advanceI have a ASA 5510 configured with three port, external, production, libraryLibrary and Production will get DNS and DHCP via Windows server (just for diagnosing i have set up ISP's DNS on library now)again for diagnostics i ha...
Great, great, great it worked.... thanks James. thanks a lot. it worked like a charm.I also had to do the NAT rules you mentioned above to get it working.Now I am stuck with SMTP - will open up a new thread.Many Thanks
well that explains why I get errors with that command.... Yes, if a PC connected to same Ethernet cable then it gets public IP and gateway from ISP, if I simply disconnect cable from that PC and connect to External port on ASA it does not get an IP ...
Thnaks James...I had to attend some Telecom problem and this task was pushed down the ladder.Now back where we left it...Yes, the default route was removed just after the original post above- it was a desperate attempt, which of course didnt workI wa...
Many thanks JamesI have done all of the stuff pointed out but still no go.. I am starting to pull my hair now...after few reboots, swapping cable back and forth with PC, DSL modem and ASA I still cant get the public IP to show up on the interface. ha...
Thanks James Denton1) Yes, it was set to 0 by default and I intend to change back to 0 - thanks for pointing out. 2) Yes, I need both subnets to have outbound Internet access – I will configure the unit and post back or ask more question...
