Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Uday,Are you able to attach a show tech-support from the WAE and a show run from the router that is doing the WCCP? If not on this forum, then we'll need a TAC case to dig deeper into this issue. The tcpdump should have shown more than it did. Y...
Hi Gary,Yes, you can make it it farm. You said that at SYN from router A may get sent to the module in router B and that is not desired.Why not, I assume it will be able to get to router B on the LAN side which is at least 100 Meg, so no harm.The ...
Hi Uday,Something is wrong here. You are seeing UDP broadcast packets, not the traffic you are trying to optimize, so I think your tcpdump didn't get the correct interface. Are you using gig 2/0, port-channel or Standby interfaces? If so, run tcpd...
Hi Uday,Well, now we have to roll our sleeves up a bit. There are a couple of possibilities. 1, Still something with WCCP. To get an optimized connection we need four separate redirections. Two on the edge, two on the Core. If it is correct, we w...
Hi Uday,Couple of things. First, I assume you have the ip wccp 61 redirect and 62 out on the same interface? You also have to look at the Data Center side. If you are using an ACL on the WCCP at the DC, make sure you have added permit statements fo...
