Well I had done all sorts of testing and stuff for the problem to still be there. Recently I had been fighting a bouncing DSL connection that would bounce from 20 minutes to an hour or so. Everything I had tried with the 18.104.22.168 firmware and the 22.214.171.124 firmware yielded the same result. If you touch any of the settings under basic wireless the speed would drop on my WiFi to 54.0MB and I would get the B/G/N-Mixed red warning next to the Wireless Network Mode. My final was to do a complete setup in 126.96.36.199 firmware, save it with everything set. Then Factory Default the router. Upgrade to firmware 188.8.131.52. Once done do a simple reset. After that reset then use the saved config file to restore the router. But my connection did not stay stable on the n speed and would drop back to G a lot. Well as I said I was fighting DSL issues which ended up resulting in a modem/gateway change. I had a ZyXEL PK5001Z. I put in my older ZyXEL PK5000Z, which is compatiable with my DSL as it was my modem at the old house. Now my DSL connection is stable. So I went and checked the router and my WiFi is a solid 117 - 130MB and if I make a change on the Basic Settings page for the Wireless I no longer get an error. So it appears my DSL modem/gateway (modem/router), an ZyXEL PK5001Z, was the cause of my router problems as well as my DSL bouncing and noise on my phone line too. At this point I am running the 184.108.40.206 firmware and I am having no problems. Thank you for at least replying Cindy Toy and Brian Ng! Message was edited by: Frederick Frahm
How do I mark this as Answered?
... View more
I recently purchased a RV120W router and I am having a problem selecting n speed under the wireless settings. If I select B/G/N-Mixed mode then when I go to save the change I get B/G/N-Mixed B/G/N-Mixed in red letters and it does not save. If I select N only then when I go to save it says in red letters N only N only. It does not matter if I pick 20 only or 20/40. It does not matter if I enable or disable U-APSD. It does not matter if I use the LSB or USB side. Firmware Version: 220.127.116.11 When I got the router it had an older firmware if I remember correctly, and it would let me change to n speed. Any suggestions?
... View more