Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a problem.I have 8 ip addresses on the outside of my PIX.I want to use the first ip address for the global statement and the 2nd for a static translation.I want all computers to use the global address but my server should use only the 2nd ip a...
Thank's for the reply.I've got one question, I allready have a nonat statement in the cconfig. It's for the vpn users.## nat (inside) 0 access-list vpnusers## access-list vpnusers permit ip .........I called the access-list vpnusers. then I use ...
Thanks but this paper tells me how to use statics but the static translation is not the problem. The problem is that the server connects a l2tp tunnel.So the server has to listen and speak with the same ip address.Bas
Hi there,Please try [write erase]Then [ reload ] with no saving the config.After reboot in conf mode [ ip address inside (ip) (netmask)]With regards,Bas
