About jagbir_singh

jagbir_singh · 04-16-2008

Dear All,I am facing this problem in one of my customers network.Two Core Switch Catalyst 6513 is having FWSM and ACE Module in failover mode. On ACE one server farm is created. VIP of this server farm is reachable from FWSM context as it is laying o...

jagbir_singh · 04-25-2006

I am facing a problem in pix515e 6.3(4) in failover mode. Problem is that when I make secondary as active firewall traffic is running fine but when I am making primary as active traffic is not smooth and there are RTOs after 10-15 replies. Again if I...

jagbir_singh · 10-08-2008

Hi Chandru,Have you got any support from TAC or any other sources as suggested by Farukh on this problem as i m facing the same problem.Thanks Jagbir

jagbir_singh · 04-25-2008

I mean to say that whatever static IP and subnet mask is provided by ISP that you had configured on outside interface. You have to put one default route via outside interface using gateway router address provided by ISP as next hop. command syntex is...

jagbir_singh · 04-24-2008

Hi,I had checked your configuration. What I am able to understand is that when ASA outside interface is configured to accept IP Address from DHCP, gateway is also configured for that interface which works as a default route. But when you put static I...

jagbir_singh · 04-24-2008

Hi,Thanks for your response. This problem is fixed with identity NAT.

Member Since	‎04-25-2006 04:04 AM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	8
Total Helpful Votes Received	5

User Statistics

User Activity

FWSM 3.1.5 not passing traffic for Virtual IP Addresses on Load Balancer

Problem with Pix515E 6.3(4) in failover mode

Re: Performance Monitor 3.2.1

Re: ASA 5505 Static IP Configuration Difficulty

Re: ASA 5505 Static IP Configuration Difficulty

Re: FWSM 3.1.5 not passing traffic for Virtual IP Addresses on L