Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco Nexus 5672UP switch running NX‑OS 7.3(6)N1(1). The switch was functioning normally, but after performing a reset, the Ethernet ports on Slot 1 (ports 1‑48) are no longer visible in show interface status or show interface brief.
The ports are unified, I've already run this command, saved, and restarted, but the ports didn't return. Only the mgnt stays, however, if I run the command 'show module 1' it shows the ports and the 'status' is 'active*'
