Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am experiencing an issue with the software image on a Cisco Firepower 1010 device.
After performing a factory reset, I accidentally erased disk0:, which resulted in the loss of the system image. As a result, the device can no longer boot and is cur...
Thank you for your help, after a lot of times of factory-reset, i configure manager local and i have access from a laptop to https server.
My pc has Internet now but i haven't access in https and ssh server. Maybe is the issue with windows defender o...
I'm not sure is the firewall from Pc, because i had tried from another pc without any active Windows Defender. The issue was the same. The pc was taken IP from DHCP server but there wasn't access to the Internet. From firewall i can ping 1.1.1.1, 8.8...
I have installed the version 7.6.2-329.SPA from another Firepower 1010. The result is that the status of the led is red and i haven't network. The DHCP protocol is enabled, i have configured one by one the steps and the protocols didn't worked.
I hav...
I understand that the two images are just an example, and that only one image can be installed on a Firepower device.
Will the serial number (SN) of another device affect the configuration of DHCP, NAT, or other services? I am asking because yesterda...
If i find a solution for a software image and then follow the below steps, i have access to GUI? Before i ask about the serial number of the Firepower, if a take the image from another Firepower 1010, should i have any issue with DHCP, NAT or HTTP ac...
