Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The Event Viewer feature, introduced in Security Manager 4.0, enables you to selectively monitor, view and examine events from ASA devices. Before you can use Event Viewer to view events generated from an ASA device, you must configure the logging po...
The 'just active' state is the first state the unit enters when becoming the active unit. During this state, a message is sent to the peer alerting the peer that the unit is becoming active and the IP and MAC addresses are set for the interfaces. T...
You can do packet captures on both sides of the firewall to verify whether the FWSM caused any delays in the file transfer. Also, please review the document below for information on how to achieve the maximum single TCP flow performance when going t...
Here's the config guide on how risk rating is calculated:http://www.cisco.com/en/US/docs/security/ips/7.0/configuration/guide/cli/cli_event_action_rules.html#wp1067121
