Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to recover my Cisco 2960X switch, but nothing is working. The switch will not boot the IOS file and shows “Image failed digital signature verification.” I formatted the flash using format flash: and after the format I only see one .bin fi...
Hello Everyone,I’m a new with Cisco Sessions and I recently received an email invite for a Cisco ACI 6.2 video session. I noticed that this webinar does not appear on the public Cisco Events page, and my colleague also couldn’t find it.I want to unde...
Hi everyone,I’m dealing with an issue on one of my Catalyst 9200 switches. The CPU sits at 97–98% almost constantly, and the top processes are always the same: SISF Main Thread, Crimson flush, and SISF Switcher Thread. Currently running IOS 17.15.4We...
Troubleshoot High CPU on Catalyst 9000 Caused by SISF Process - CiscoHere is the solution. Used the command on every switch trunk port, It fixed device-tracking policy DT_trunk_policy
Got it. But we did 9K switches with usb drive and there is no problem for those but for some reason only 2960 having problem.But I'm going to try .tar file.Thanks,
I check MD5 Checksum after copying to the file into the switch. On format flash: Not sure how that .bin is available.I use XMODEM to transfer the .bin and its working (its same .bin) but not sure why not for usb is not working.| Edit: I just checked...
Here is the output, not sure how to upload in doc.000059: Mar 24 2026 20:37:25: %USBFLASH-4-FORMAT: usbflash0 contains unexpected values in partition table or boot sector. Device needs formatting before use!usCDGsw-acc-Temp-IT_Trailer-Clubhouse#00006...
