Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I'm currently trying to set up a new router in my company's network.
Everything works fine concerning Internet access, unfortunately my company is using a software which has to go through a VPN (another Cisco router) using a static route, and ...
Hello,
I'm currently trying to set up a new router in my company's network.
Everything works fine concerning Internet access, unfortunately my company is using a software which has to go through a VPN (another Cisco router) using a static route, and ...
Hello,
Thanks for your answers,
I've been trying your solution by adding the Nat rule to the firewall:
nat (inside,inside) 1 source static any any destination static 192.168.210.1 192.168.210.1 no-proxy-arp route-lookup
Unfortunately, I'm still unabl...
The Cisco VPN is already configured and works fine. Its outside subnet is 255.255.255.192.
What is the hairpining for?
Once the Asa well configured, it will replace the Netgear and I will have to change the IP from its Inside interface from 192.168.5...
Hello,
The database is hosted by the software's company which provide us the public IP.
The software is based on a web interface, so its traffic, using the Gateway set on every internal device, go to the Netgear which route it to the VPN.
Here is a n...
