Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, please forgive if this is a stupid question. I'm still learning my way around. I did some searching but still feel like I don't understand. I was tasked with configuring a Meraki MX68W. 2 Users will connect direct to ports, 3 users will co...
Hey there, sticking with the steps I did was good enough.I go to Network to make sure I'm on correct group. Then below that I have access to Security and SD WanIf you don't see it, you might not have rights? If you see Appliance Status then you know ...
Interesting thing, it kind of worked.It blocked a unauthorized user from outside network access but I was hoping to block internal network access as well.I had to create a L7 rule that blocked my entire network to somewhat achieve what I wanted. Of c...
OK, maybe I have this down. Here are my steps. Can someone please confirm1. Make sure I'm under the Network I created2. Go to Security & SD WAN - Firewall3. Add rule Deny Any Any4. Go to Network-Wide - Clients5. Add Clients to : Allowed ListDoes th...
ok, I see what you're saying...if there is a template applied to other Meraki's, and I go to Network-wide to create a group policy for my network (which is not under any template) will this affect other Meraki's? I'm just trying to be cautious I don'...
