Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I tried upgrading a 520 from 2 MB to 16 about a year ago. I was unsuccessful because there was no 2 MB module that I was able to remove. Everything is soldered onto the motherboard....I found out from TAC recently that if you have smartnet on the u...
I completely agree. The PIX failover concept is that the two units are really one. If any part of the primary PIX goes bad, the whole unit is considered bad, and the secondary takes over all operation from the primary. At that point, the failed pr...
that is the complete "global" command you need. By saying "global (outside) 1 interface" you are telling it use the outside interface.Then you need your nat command, something like this:nat (inside) 1 192.168.0.0 255.255.0.0keep in mind that you mus...
