Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Z3 stand alone network being used for a club has been experiencing a number of IP Conflict alarms by seemingly one device ... the MAC within the Client list suggests this is some kind of android device ... the logs suggest it is requesting DHCP servi...
Looking for some ideas on how to mitigate recent alarms without turning off the Alarm Monitor ... thanks in advance for any insight you can provide.Recently have started getting a wack of IP Conflict Alarms from 3 independent Meraki Z3 routers ... lo...
Not using the Meraki Z3 Wifi due to its physical location ... instead, we have 2 APs connected: one centered inside a 2 story building (Dlink), the other outside (Cambium) ... if I go to the Meraki dashboard, I can see a list of wired and wifi connec...
Z1 set with 192.168.210.0/24 for the LAN and 192.168.209.0/24 for the VPNAll Permanent clients have been assigned Static IPs to allow remote port forwarding and remote support.Trying to isolate one PC on the INTRANET (LAN CLIENT) from seeing or inter...
Can anyone clarify how the Z3 client list might be generated ... at a high level, expecting there may be one of two methods OR a combination of both methods ... could be other methods ... just attempting to understand my finding listed belowMethod A)...
Cambium cnPilot is an AP with the gateway (gateway is the Z3) defined to provide DHCP service so don't think it is acting as a router ... as stated in my previous reply to you the Cambium traffic appears to be listed but perhaps the non explicit rese...
no apologies are required ... appreciate the feedbackOf the 507 available addresses with a 23bit mask, the Z3 DHCP has been set to have 300 unreserved addresses, 207 reserved addresses with 17 of those staticThe client list is confusing because it cl...
ok so I have applied a group policy with Layer 3 of deny 192.0.0.0/8 and Layer 7 deny p2p ... YET ... I can still ping any of the 192.168.210.0 or 192.168.209.0 devices ... am I doing something wrong or am I misunderstanding the guest example given b...
