Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We just recently installed the MT14s and are powering them POE via USB-C to Ethernet. My email and phone are getting slammed with "Sensor stopped alerting:" notifications. Under Alert Profiles>Sensor Status Alerts, I have the boxes checked for "A sen...
I've connected two switches via a LAN connections and they both were getting NAT Type B connections. My assumption (rightly or wrongly) is that since the change happened at the MX level and not the switch level, that it should work for any other Nin...
After opening an additional case, and essentially asking for a second opinion, another support tech told me that they would be able to help. Unfortunately, I can't tell you exactly what they did, because when I asked them what they did to remedy the ...
We are having the same issue right now and when I contacted Meraki support I was basically told that our firewall (MX250 with firmware MX 18.211.2) is just not cable of allow a change to NAT type A or B connection. I was advised that our only solutio...
This post has been here for a while, but I'd encourage anyone who has been using the MT14 to share a workflow or some tips for determining if a specific reading is recognized for vaping versus cigarette smoke or from other "smoke-able" items. The thr...
Truthfully - I need to find someone with a vape pen and some cigarettes and just see what the environment looks like under these conditions. Thanks for following up. It was helpful!
