Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI have already set up a Dynamic PAT ( manual NAT) for Internet traffic as follows:object network obj_any-insidesubnet 0.0.0.0 0.0.0.0nat (inside,outside) source dynamic obj_any-inside interfaceEverything was good until, I started to receive a ...
thanks again JouniNow I'm using the following configs , and it seems that is working as expected. Now I only need to wait to exhausted the "interface" PAT address in order to confirm that uses the next PAT address defined on the range:object network...
Thanks Jouni , let me try combine both . I haven't checked the "show nat pool" , and most of the traffic is Internet Traffic , since this firewall is only for Egress Internet for all users, I could say that is the only NAT/PAT that we are running on...
