Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to perform static Nat's through an internal network?Here's my situation I have a ASA 5510 with a public outside interface (let’s call it 68.68.68.1), and I have an inside private IP address (192.168.1.2/24). The inside IP address leads...
I was wondering if anyone can help me out. I am trying to create a redundancy topology which require several connections to an ASA 5510. I am looking at extending the connections to my ASA 5510 appliance with the four port gig ethernet security modul...
I have a similar problem, as I have a ASA 5510 connected to a 4900 switch with VLANs. I have a outside interface and an inside interface on the ASA 5510 which routes traffic to the multiple VLANs on the 4900. My issue is specifically one of my VLAN...
This is the hold ouside_access_in currently actived.1 True any 68.68.68.1 (interface) icmpicmp/echoicmp/echo-reply Permit Default 2 True any 68.68.68.1 icmp/time-exceeded Permit Default 3 True a...
more information as requestedcsc# sh int ip brInterface IP-Address OK? Method Status ProtocolEthernet0/0 192.168.1.2 YES CONFIG up upEthernet0/1 172.16.2.3 ...
The following was applied static (inside,outside) 68.68.68.222 192.168.2.60 netmask 255.255.255.255access-group outside_access_in in interface outsideroute inside DMZ-network(which is 192.168.2.0 255.255.255.0 192.168.1.1when I try to access the serv...
