Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a rather odd issue occurring and can't seem to figure out the source and ultimately the resolution.Current environment:MX84 + (2) MS220 stackedWAN1 broadband ISP & WAN2 Fiber ISPMultiple VLANs (1) Data & (3) VoiceSwitch Settings > QoS = config...
In the event of someone else experiencing the same or similar issue, I am going to test the current change suggested by @Philip D'Ath for a couple of days. However, immediately after changing the Flow Preferences for the voice VLAN to have the specif...
Thx @Philip D'Ath ... I do have loadbalancing disabled. However, I currently have the Flow Preference of the voice VLAN set to ANY destination. I will change that to the specific public IP addresses of the VOIP provider.I did or have verified that th...
Yes. Both WAN1 and WAN2 of the MX84 has their own IP address. Both ISP devices are in passthrough mode.Firmware on the phones? Note, I have two sets of physical phones operating differently as of my test. 8 or so phones on the same VLAN (1) with no e...
