also to note...Let's say you put a N55-M16UP GEM card in slot 2 in a N5548UP and you just want FC on that module. You can just 'poweroff module 2' and 'no poweroff module 2' without having to reload the whole thing.However if you want some of the bas...
Hi Steve,Seth Mason talked about in this post: https://supportforums.cisco.com/message/3571541#3571541NPV and NPIV work great together, however you can enable NPIV without using NPV.NPIV is just a way to allow many FC initiators to flogi into a switc...
Eric - Is this nexus switch with FCoE or FC connected hosts?In my enviroment with FCoE I would use: show flogi databaseIf doing FCoE you'll get the interface (vfc#), vsan, fcid, pwwn and device alias (if used). If you name your vfc/po in a creative w...
In addation to Jeremy, you can also do a:show sprom backplane 1You'll see the serial number in there. There is a secondary serial that sometimes OSM's like to have. You can find this by either looking at the front or bottom of the switch or running t...
