Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i have difficulties to get PXE-Boot working in following scenario:Client is in Subnet 1 behind the FWSM (inside interface).Server is in Subnet 2 behind the FWSM (inside interface).Both, client and server have public IP-addresses, so no NAT is need...
Hi Mike,the three shows give emtpy respond, NAT is not enabled cause of using public ip addresses.The version of FWSM software is 4.1(7) and runs in routed mode, multi context.Thanks,Juergen
