IntroductionPrerequisitesConfigureVerifyRelated Information Introduction This document provides a sample configuration of stub multicast routing on the ASA and how to test using third party tools. PrerequisitesRequirements The document assumes the r...
Introduction Core Issue Resolution Related Information IntroductionFirewalls, such as Cisco ASA and FWSM, use statefull inspection to protect traffic flows. One major requirement of successfully implementing statefull inspection is that both requ...
Introduction Core Issue Resolution Related Information IntroductionFirewalls like Cisco ASA and FWSM use statefull inspection to protect traffic flows. One major requirement of successfully implementing stateful inspection is that both request (T...
If you want to see the error message, start adding "Rendezvous Points" both on the ASDM and CLI while the igmp forward is enabled on any interface. Enabling or disabling PIM on the interface doesn't trigger the sanity checking.
The instructions above is specific to the "mfib forwarding" command. We may need to correct our documentation.If you are looking for the "igmp forward .." command, go to Configuration -> Device Setup -> Routing -> Multicast -> Protocol. Select the in...
See below response.[Question] Should I configure the ASA with PIM routing and a static RP address (plus the ACL to allow the multicast source traffic in) since the receiver hosts are a couple hops away? [Answer]: You need to enable PIM routing on ...
The public smtp server might be using ESMTP rather than SMTP. If so, use "match protocol smtp extended" instead. If that's not it, you might want to open a TAC case to investigate further.
Let me try to answer the two questions. I'll add the scrapes so that its easy to identify which answer is what for question.Question #1... The Cisco documentation says to enable active/active failover multiple security contexts are required. Most ...
