Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I would like to verify the VRF (Virtual Routing and Forwarding) capabilities for the Cisco Firepower 1010 (FPR-1010) hardware.Currently, the appliance is running FTD software version 7.4.2-172.Could you please confirm:-> Is VRF fully supported ...
I was wondering if I can create VRFs in this model, and if so, how to do it.It doesn't seem to have an option to add them, as shown in the image below: I need 4 VRFs to isolate the interface routes.
