Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am having a problem with address translation on a pair of Cisco ASA firewalls when they failover.The current setup has 2 x Cisco ASA5520 firewalls configured in active/standby failover. I have address translation configured on the ASA using both...
I am looking into monitoring an IPS device at a remote site over the internet. I would like to install IME at my main site and have IME connect to the SSM module at the remote site over the internet. Can anyone offer advice on the TCP ports required...
I have a requirement to configure WCCP on the Nexus 7K for redirection of traffic to a WAN optimiser. I have multiple sources and destination that require redirection and therefore multiple source and destination interfaces.To reduce configuration co...
I would like to setup an ASA5505 with dual ISP connections. Both of the internet connections authentication and obtain their IP address and default route using PPPOE setroute. When I have configure dual ISP support on ASA's in the past I would norma...
Hi, they are running 8.4(2).The outside is connected to different switches using the same VLAN and HSRP as the upstream gasteway. The inside is connected to two different switches internally using one VLAN and no routing on the switches.Thanks
We used 'in' and 'out' on the same interface to avoid having to make changes on a critical port-channel. Just remember to use exclude-in on the wccp port to avoid loops if you do this.I experienced a number of issues most relating to the traffic defi...
Hi,Further to this configuration, I have a requirement to send more traffic to the optimzer from a different source/destination interfaces for different clients.Can I apply the WCCP redirection to multiple interfaces as below or is it recommended tha...
Hi Bhavin,If I only want to redirect traffic between the networks 10.10.10.0/24 and 20.20.20.0/24 and have all other traffic route normally can I configure an acl as follows?It isn't going to be possible for me to have a deny first for all unwanted t...
