Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,This is just an general question. We have two subnets on our network. Both these networks are routed. We have Cisco 1721 Router. It has only one Ethernet Module. We cannot user another. It is the gateway for subnet1 and subnet2. subnet2 gatewa...
Hi,After setting both sides to auto and changing the cables, there are no CRC errors now. Seems the network response was slow due to bad cables. The Switch was showing input/output packets during business hours. And there is considerable difference t...
Hi,Well, to clear myself, i set both sides to auto as below,Switch(config)#int fa 0/3Switch(config-if)#speed autoRouter(config)#int fa 0Rotuer(config-if)#speed autoYet i do not see any input/output packets in the switch. But there are no CRC errors o...
Yes, cdp neighbors shows it is connected to this switch on fa 0/3 port.Also i changed the cable with new one. Its confirmed.here is the output from the switchSwitch#sh int fa 0/3FastEthernet0/3 is up, line protocol is up Hardware is Fast Ethernet, a...
Hi,I changed the cables with new/good ones.Then cleared the counters.Yet there are CRC errors.Further to mention, The router is not directly connected to the switch. We have a compression router in between. The connection from router goes to this dev...
Hi,Thanks for reply,I cleared the counters on Router. Yet there are CRC errors. Yet there are CRC errors in the Router. I will change the cable with a branded good cable.then will clear the counters again and post the sh int from Router and Switch to...
