Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We just had an engineer configure our firewall and now, I can't access inside resources from inside, using the outside IP address. For instance, we have a webmail server with NAT which works perfectly from outside the firewall but if I am inside ...
Hi, I have a new 5510 that I have enabled smtp service but when I try to telnet to the firewall port 25 the display is just garbled characters and it wont allow the connection to my server. What could I be missing in the config?
Thanks to all who contributed to my question. I just found out that my ISP had another route set up on my connection instead of bridging it. Now, I have to start from the beginning because I may have had it configured right at first.
This did not work either. I get the same response. I saw this problem once before about 5 or 6 years ago and I think it had something to do with a protocol not being enabled but I can't remember....
